# Console

> How to reach your server from the browser when the network or SSH is not working.

The console opens your server's screen directly in the browser. It does not need the network, SSH or firewall rules. Use it if the server does not boot, the network settings are broken or you lost your SSH key.

## Opening the console

1. Open your server under **Services**.
2. In the **VM Management** panel, click one of the two buttons:
   - **Console**: the server's graphical screen. Works for Windows and Linux.
   - **Serial**: a text terminal. Shown only for Linux servers that have a serial port.
3. The console opens in a new tab. The status shows "Preparing…" and then "Connecting…". When it says "Connected", the console is ready.

The console buttons are shown only while the server is running. If it is stopped, start it first.

## Signing in

The console itself needs no password; the portal opens the connection for you. Sign in to the operating system with the server's username and VM password.

- The **username** is shown in **Login user** on the service page.
- The **VM password** was given when you ordered and was e-mailed to you.

If you don't know the password, click **Reset password** in the **VM Management** panel:

1. A new password is generated. You can also type your own: at least 12 characters, with upper and lower case letters and a digit.
2. If the server is running, the password takes effect only on the next start. Choose **Restart now (about 1 minute of downtime)** or **I will restart it myself later**.
3. Click **Set password**. Save the password right away: it is shown only once.

You can reset the password up to 3 times per hour. The disk contents are not touched.

The password is applied on the server by cloud-init (cloudbase-init on Windows). After the server reboots, the **Check on server** row in the **VM management** panel shows the result: **Applied**, **Not confirmed: check on the server** (the QEMU agent does not respond) or **Not applied on the server** (cloud-init did not run; change the password manually from the console). The portal reads the result from the agent on the server and does not count the accepted request as done.

On Linux this password is for the console only. SSH does not accept passwords, it uses your key: see [SSH key](https://jezahost.com/en/help/vps/ssh-key).

## Useful buttons

- **Ctrl+Alt+Del**: needed for the Windows sign-in screen. Available only in the graphical console.
- **Full screen**: opens the console on the whole screen.

## If the connection drops

If you see "The console connection was closed", refresh the page.

If you open the console too often, you may see "The console is being opened too often". Wait a few seconds and try again.

---

Source: https://jezahost.com/en/help/vps/console
Updated: 2026-11-15
Portal: https://cloud.jezahost.com/services
